MON-SAT: 11-7 | SUN: 11-5 | 888-686-7872
The Jim Kelley™ Amplifiers Single Channel Reverb Combo is a 60 watt all-tube amplifier designed to retain your guitar's natural tonal characteristics. It delivers a broad range of punchy, high powered clean and smooth dynamic overdrive tones. The Single Channel model features a versatile pre-amp/power amp circuit, active shelving tone controls, four 6V6 output tubes and reverb.
Output: 30/60 Watts
Tubes: 4-6V6, 3-12AX7 & 1-12AT7
Fuse: 3 Amp Slo-Blo
Front Panel: Inputs, Gain, Treble, Bass, Reverb, Power Select and Power Indicator
Back Panel: Mains Inlet, Stand-by, Speaker Outputs, Reverb (send and return) and Boost jack.
THREE-POSITION POWER SELECT SWITCH:
30 Watts: Amplifier operates at half power
OFF: Power is switched off
60 Watts: Amplifier operates at full power
Operates as an overdrive and a volume control. This is responsible for adding harmonic sustain, richness and depth at higher gain settings.
Located on the Gain control, this adds high frequencies by altering the power section's negative feedback.
Adjusts the boost and cut of treble frequencies. When control is set to "5", treble response is considered flat.
BRIGHT (PULL TREBLE)
Located on the Treble control, this provides an additional boost of treble for a glassy edge.
Adjusts the boost and cut of bass frequencies. When control is set to "5", bass response is considered flat.
MID-BOOST (PULL BASS)
Located on the Bass control, this adds thinkness and sustain for "fattening up" lead tones.
Adjusts the amount of reverb effect that is added to the original signal. Turning the knob fully clockwise will provide the maximum reverb effect.
HI: Use this input for guitars with passive or high impedance pickups.
LO: Use this input for guitars with active or low impedance pickups.
Provides a Post-EQ boost in gain to the output section for more saturation while leaving the pre-amp clean and punchy.
The Single-Channel has two loudspeaker outputs and utilizes a custom built output transformer and has two loudspeaker outputs (one 8Ω and one 4Ω) to interface with a variety of speaker cabinet options.
With the Power switch in the OFF position and the Stand-by switch in the Stand-by position, flip the power switch to ON. Wait sixty seconds, then flip the Stand-by switch to the ON position. To power down, switch the power switch to the OFF position.
Fitted cover for the Fishman Loudbox Artist Amplifier. Custom designed for Fishman, this nylon slip cover features an opening for the amp handle so it's easy to carry and a Velcro®...
From its humble origins in the back of a small music store in London, Marshall Amplification has defined the sound of rock for generations of guitarists around the world.The History...
The classic 'curly cable', the VCC has been part of some of the most historic moments in rock and roll history. A unique multi-gauge design uses individual conductor types that...
The new 44 Magnum guitar amp head provides 44 watts of clean and natural power but can also deliver a true amplifier overdrive at the turn of a knob. From...
Subscribe to our email newsletter for all the latest gear news and updates.
© 2017 Chicago Music Exchange. All Rights Reserved. 3316 N. Lincoln Ave Chicago, IL 60657 (773) 525-7773.